Alt-BEAM Archive
Message #13352
To: beam@sgiblab.sgi.com
From: beam@sgiblab.sgi.com
Date: Tue, 11 Apr 2000 09:57:51 -0400 (EDT)
Subject: BASIC Stamp
Does anyone have a BASIC Stamp 1 or 2 they would like to sell to me?? the BASIC Stamp 2 would be prefered, and if you have the board for it I'd also like to buy it.
Please contact me off the list at jester96@iname.com cause I know it's not really BEAM related.
Chris
---------------------------------------------------
Get free personalized email at http://www.iname.com
13353 Tue, 11 Apr 2000 07:27:30 -0700 RE: Walker "hanging" gait problems "'beam@sgiblab.sgi.com'" Wilf Rigter Use a ohm meter to check continuity of the traces. The circuit hanging like
that gives a clue: the common line for the resistors is suspect.
regards
wilf
> -----Original Message-----
> From: Bernard Nazari [SMTP:Bernard.Nazari@jpl.nasa.gov]
> Sent: Monday, April 10, 2000 7:34 PM
> To: beam@sgiblab.sgi.com
> Subject: RE: Walker "hanging" gait problems
>
> Hi Wilf,
> I'm using a 6 neuron microcore. Its basically the three motor
> Chiu-style walker. I'm also using Bruce's PNC to get the whole thing
> started. The sequence stops on one LED (010000) and it doesn't
> continue...or it pops into a 010100 and stays stuck on that. JPL.
13354 Tue, 11 Apr 2000 07:27:41 -0700 RE: motor problems (nobody knows???) "'beam@sgiblab.sgi.com'" Wilf Rigter There are some good SE tutorials but most describe a specific SE and not the
general principles of Solar Engine design and how to optimize for different
applications. This question has come up many times on the list before, so a
search of the BEAM list archives should yield valuable clues. Otherwise why
don't you tell us which SE you are using then go through a mini SE circuit
analysis on-line and tap into some expert opinions. Warning though, such
discussion can get quite detailed.
regards
wilf
> -----Original Message-----
> From: Aaron Letts [SMTP:beamlist@yahoo.ca]
> Sent: Monday, April 10, 2000 7:46 PM
> To: beam@sgiblab.sgi.com
> Subject: RE: motor problems (nobody knows???)
>
>
> > Otherwise you will have to tweak the SE components
> > to match the motor specs and learn a lot about SEs
> > in the process.
>
> Wilf:
>
> Where can I go to find info that would help me on
> this?
> Thanks again,
>
>
> Aaron
>
>
13355 Tue, 11 Apr 2000 11:04:21 -0600 Re: Re. Englissi beam@sgiblab.sgi.com CORBIT GIBERSON Yeah..........Like this one ;-)
Buzz wrote:
> One other thing, I have noticed a massive increase in the amount of non beam
> and personal messages on this list since I was last on it. Remember people,
> we have to wade through every non beam post that occurs to find the real
> beam related articles.
13356 Tue, 11 Apr 2000 13:26:13 PDT Magbot butterfly beam@sgiblab.sgi.com "leif_ 74" i'm wondering how you make the wings on a butterfly flap.
Thanks,
Eric
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
Home