Alt-BEAM Archive
Message #11933
To: beam@sgiblab.sgi.com
From: Corey Centen biobotics@hotmail.com
Date: Wed, 15 Mar 2000 20:25:50 -0500
Subject: FRED bread boarded...problems
> Hi all, sorry to bother again,
>
> I just bread-boarded FRED but it didn't work. The FLED would flash but the
> motor would not turn. I only bread-boarded half the circuit, or one
engine.
> I don't know why this is. Where does the second wire of the FLED go? Any
> help would be appreciated.
>
> Also...
>
> If I use a larger voltage than something like a 2 or 3 volt solar panel,
do
> I need a larger cap?
>
> Thanks!
> ______________________________________________________
>
11934 Wed, 15 Mar 2000 18:40:53 -0500 Re: power smart head Darrell Johnson
> here you go: It's slightly modified in that I put pin
> numbers in red on the inverters.(to help somebody out
> long ago..) Otherwise it's the drawing that Wilf made.
> What's the matter? Don't trust *my* schematic? ;)
>
> darrell
>
>
> --- Bumper314@aol.com wrote:
> > I was looking for the very original, with just the
> > inverters diagrammed, not
> > the chip pinout kinda version
> >
> > Steve
> >
>
> =====
> ____________________________________
> BICOREEOS... They're BEAMtastic!!
> http://www.geocities.com/beamtastic/
>
> __________________________________________________
> Do You Yahoo!?
> Talk to your friends online with Yahoo! Messenger.
> http://im.yahoo.com
----------------------------------------------------------------------------
----
Home