Alt-BEAM Archive

Message #11590



To: beam@sgiblab.sgi.com
From: Richard Piotter richfile@rconnect.com
Date: Fri, 10 Mar 2000 19:47:13 -0600
Subject: [alt-beam] Re: ARGGGGHH!!!!


Try not swtitching wires, but physicaly moving the eyes into opposite
spots (switchem around). Make sure that if you change the wiring, that
polarities are the same.

BUDSCOTT@aol.com wrote:
>
> In a message dated 3/10/00 6:41:54 PM Central Standard Time,
> richfile@rconnect.com writes:
>
> << Your photodiodes are wired to the wrong sides. Switch the wires or the
> photodiodes around.
> >>
>
> tried it, for some reason he just doesn't like it when i do that! its kinda
> wierd, when i change it, it only turns one way even when i flip the diode,
> however if i put them back to the same old anti-phototrophism it works! wierd
>
> -Spencer

--


Richard Piotter The Richfiles Robotics & TI web page:
richfile@rconnect.com http://richfiles.calc.org

-- Make Money by Simply Surfing the Net or responding to E-Mail!!!
-- Click below!!!

http://www.alladvantage.com/go.asp?refid=ATL147
http://www.spedia.net/cgi-bin/dir/tz.cgi?run=show_svc&fl=8&vid=329630



11591 Fri, 10 Mar 2000 02:20:46 -0500 Re: Pager Motor
> If you look at the BEAM archive (web URL anybody?) there is a set of email
on
> those damn little eccentrics on the pager motors. I had one helluvatime
> gettin those off, sometimes they use a type of epoxy to hold the buggers
on
> em! GOOD LUCK!
>
> -Spencer
>

Home