Alt-BEAM Archive
Message #04819
To: beam@corp.sgi.com
From: Jason - evenflow88@hotmail.com
Date: Wed, 23 Jun 1999 14:04:20 GMT
Subject: [alt-beam] Walker problem(microcore)
hie
okay...here is the problem....i used the PCB from the beam heretics...which
states Hx1.0 in bigfoot....alfter building it...the core work fine after the
PNC is on for a few sec the single process take place(a 106 cap as for
decoupling)...then after i wire the motor driver(74hc245 and h-bridge,i
tried both) down the microcore goes haywire no matter where the enable line
is?
p/s:the h-bridge is from ian's site(psst!note to ian...the tutorial for the
h-bridge is wrong i hope u go correct it)and 100k resistor and for the
74hc245 at first i mount the enable line to the GND didnt work,then i wire
it to the PNC ddidnt work either...so can anyone help me please
jason
______________________________________________________
------------------------------------------------------------------------
eGroups.com home: http://www.egroups.com/group/alt-beam
http://www.egroups.com
- Simplifying group communications
Home