Alt-BEAM Archive
Message #04405
To: evanhk@interchange.ubc.ca
From: JVernonM@aol.com
Date: Thu, 10 Jun 1999 00:26:25 EDT
Subject: [alt-beam] Re: SE questions not found in the FAQ.
In a message dated 6/9/99 11:35:31 PM Eastern Daylight Time,
evanhk@interchange.ubc.ca writes:
>
> Well, that's the fun of it... think of the chip as many individual
> components, then you'll be able to envision and build the circuits. The
> best way to learn would be to check out the data sheets. (That way, if
> you're freeforming, you can build it like you want it to be too). When
> looking at the bicore "component schematic", you can practice redrawing
that
> into a "regular schematic", then you'll get the hang of it.
Hi Evan,
Yes, I understand the chip specs. I just thought it would be easier for the
novice. BEAM as a starting point hobby and all that. Besides, I'd rather be
up to my elbows in caps and motors while sniffing solder fumes. Any short cut
to building is fine with me. Thanks for the advice just the same.
Jim
------------------------------------------------------------------------
eGroups.com home: http://www.egroups.com/group/alt-beam
http://www.egroups.com
- Simplifying group communications
Home