Alt-BEAM Archive
Message #04095
To: bumper314@aol.com
From: Darrell Johnson wundoba@pacbell.net
Date: Mon, 31 May 1999 22:32:12 -0700
Subject: [alt-beam] Re: unicore beam ant questions
I just got to the page a little bit ago...
as far as resistor values, I'm sure they're pretty flexible.. most of
them will probably be up in the megaohm range. Depends on how you want
the master slave bicores to interact.
I'm still in the process of breadboarding the circuit.. as I'm sure a
bunch of people now are. Hope I didn't knock too much wind out of your
sails Ian. ;)
Seems like pretty standard stuff.. Not too far off from what some of us
on the list are working on, except for the added Nv's coming out of the
master/slave bicore that run the motors opposite the 2 Nu-
have fun kiddies!!! :)
Darrell
http://home.pacbell.net/wundoba
Bumper314@aol.com wrote:
>
> In a message dated 5/31/99 9:57:41 PM Pacific Daylight Time,
> wundoba@pacbell.net writes:
>
> > because the schematic is right here....
> > http://www.beam-online.com/Robots/BeamAnt/
> >
> > you really gotta seal off your webpage better Ian.... :)
>
> so have you worked with it yet. I found this at about 5 or so, and i have it
> breadboarded. If you have started work, what values did u use?
>
> Steve
------------------------------------------------------------------------
eGroups.com home: http://www.egroups.com/group/alt-beam
http://www.egroups.com
- Simplifying group communications
Home