Alt-BEAM Archive
Message #04016
To: beam@sgiblab.sgi.com
From: Don Papp donp@cronus.oanet.com
Date: Mon, 31 May 1999 01:09:15 -0600 (MDT)
Subject: [alt-beam] Potential Walker Motors at http://www.allcorp.com/
Picture of em right on the front page. We're all always looking
for gearmotors - BG Micro only has those lens motors once in a blue moon,
and hacking servos gets expensive...
These are 7.50 each, but 6$ in an order of 10 or more. Not cheap,
but not too bad, either.
(messy quote that I havem't bothered to clean up here - that is beacuse I
am a lazy, lazy man)
Omron # R2DG-41
These unusual little
motors have built-in
control circuits that
allow them to be
usedin a continuous
or a pulsed mode. In
continuous mode the final drive gear turns
at 22-45 RPM (3-6 Vdc). In the pulsed
mode the final drive gear turns one
revolution each time the controller is
momentarily pulsed. The motor assembly is
1.75" x 1.25" x 0.5" overall. The nylon
final
gear is 0.62 diameter and has a little
nipple
slightly off-center to which a small
push-rod could be attached. Motors are in
good condition, removed from equipment.
Hook-up instructions included.
| Donald Papp, T.T., MCP
| Support Analyst
| OA Internet Inc.
| don@oa.net
------------------------------------------------------------------------
eGroups.com home: http://www.egroups.com/group/alt-beam
http://www.egroups.com
- Simplifying group communications
Home