Alt-BEAM Archive
Message #03814
To: beam@corp.sgi.com
From: James Taylor edgar_the_hate_bug1@yahoo.com
Date: Thu, 27 May 1999 17:45:28 -0700 (PDT)
Subject: [alt-beam] Microcore, and Motor Driving
Hey guess this might be a good time to throw in
another microcore question.
Well for about the 5th time I tried to drive 2 BG
micro gear motors from my Microcore. I'm using the
245 motor drivers, it seems that 2 sites conflict on
how to do this. Andrew Miller has the Dir Pin,
connected to the Ve+, however Chui has the Dir tied to
the ground. When I run a Chui setup all I get are hot
chips, whats wrong? Also what should I tie the E pin
to? That seems to conflict also. I'm not using a PNC
by the way.
===
Everything I say can mean one of two things...If something I say makes you mad....I meant it the other way.
James Taylor
URL: http://fly.to/springmeadows
------------------------------------------------------------------------
eGroups.com home: http://www.egroups.com/group/alt-beam
http://www.egroups.com
- Simplifying group communications
Home