Alt-BEAM Archive
Message #02937
To: NSX - evenflow88@hotmail.com
From: Chiu-Yuan Fang chiumanfu@home.com
Date: Tue, 04 May 1999 15:42:35 -0700
Subject: [alt-beam] Re: Multiplexer
If you stack driver boards you can enable the "normal" board and the enable
going to the "reverse" board will be fed through an inverter which makes the
"reverse" 74xx245 high impedance state.
When the reverse switch is triggered, the enables toggle and the "reverse" board
is enabled and the "normal" board is in a high impedance state.
I'm not sure if that is what is going on but that's my interpretation of the
comment. Make sense?
Chiu
NSX - wrote:
>
> hie all ,
> in robotcentral in the hextiles board section i noticed in the hextile DX
> 1.1 which explained something like this:
>
> Driver Hextile [Dx 1.0 and 1.1]
> A general purpose motor and driver board using the
> 74xx245 Octal Driver. The 1.1 features better use of the
> chip enable so tha boards can be stacked to act as motor
> multiplexers.
>
> i thought 74xx245 are just motor drivers but here it stated out that it
> could be a multiplexer...doesnt make any sense does it....hope someone will
> explain here...
>
> ______________________________________________________
>
------------------------------------------------------------------------
eGroup home: http://www.eGroups.com/group/alt-beam
http://www.eGroups.com
- Simplifying group communications
Home