Alt-BEAM Archive
Message #00352
To: "'TurtleTek@aol.com'" TurtleTek@aol.com
From: Hyndman hyndmanm@cadvision.com
Date: Fri, 12 Feb 1999 12:25:08 -0700
Subject: [alt-beam] Re: 3.6v ?!
>> Check your soldering!
>Not to sound ungratefull, but what exactly am I looking for? A loose joint? A
>short? And why would the light play a roll in this problem if bad soldering is
>to blame?
You'd be looking for Cold solder joints, solder bridges. Spray flux remover
over the board and wipe it off. Unless your using Hydro-X or alike solder,
then just spray water on it and wipe it off.
Devin
------------------------------------------------------------------------
eGroup home: http://www.eGroups.com/list/alt-beam
Free Web-based e-mail groups by eGroups.com
Home